Harbor-freight-tools PACIFIC HYDROSTRAR 97005 User Manual download pdf (Page 12)

Page 12SKU 97005 For technical questions, please call 1-800-444-3353.

Then, turn the engine Choke (41) to 3.

its “CHOKE” position. Set the Choke

in the “RUN” position when starting a

warm engine. (See Figure E.)

Grasp the Starter Handle (1), and pull 4.

slowly until resistance is felt. While

holding the Handle, allow the Starter

Rope to rewind slowly. Then, pull the

Starter Handle with a rapid, full arm

stroke. Once again, while holding

the Handle, allow the Rope to rewind

slowly. Repeat as necessary, until

the engine starts. (See Figure G.)

After the engine starts, and once it 5.

starts to warm up, slowly move the

Choke (41) to its “RUN” position.

(See Figure E.)

Pressure Washer Operation

IMPORTANT! NEVER allow the 1.

Pressure Washer to sit idle with

the Engine running for longer than

two minutes. The unit will build up

heat when it is on standby mode.

Turn on the water supply, press in on 2.

the Safety on the Spray Gun (6) and

squeeze its Trigger until water ows

out of the Gun without sputtering.

This removes air from the system and

allows the unit to properly perform.

Failure to follow this procedure

can damage the Pump.

Hold the Spray Gun (6) rmly with 3.

both hands. Point the Nozzle (9) in

a safe direction. Then, disengage

the Safety and squeeze the Trigger.

Make sure to turn off the Engine

whenever the Spray Gun is not in

use. Clean the area, following the

tips contained in the “Operating

Tips” section.

When nished spraying, press in to 4.

fully engage the Safety on the Spray

Gun (6). Turn off the Engine, and

turn off the water supply. WARNING!

Do not disconnect the High Pres-

sure Hose (8) or water inlet hose

until all pressure is discharged

safely.

IMPORTANT! 5. When turning off

the unit after use, high pressure

will remain inside the unit’s High

Pressure Hose (8), and the water

inlet hose. Point the Spray Gun (6) in

a safe direction and hold the Trigger

down for several seconds or until

water stops owing from the Spray

Gun. The High Pressure Hose and

water inlet hose can be disconnected

after the pressure is released.

Store the Pressure Washer and all 6.

accessories in accordance with the

directions in the “Storage” section of

this manual.

IF ANY UNEXPECTED PROBLEMS

ARISE, PLEASE REFER TO THE “TROU-

BLESHOOTING” SECTION AT THE END

OF THIS MANUAL.

OPERATING TIPS

Adjusting The Spray Pattern

You have a choice of four different 1.

color-coded Nozzles (9) giving you

different spray patterns.

0° Nozzle (colored red):2. This Noz-

zle delivers a pinpoint stream and is

extremely powerful. It covers a very

small area of cleaning. This Nozzle

should only be used on a surface that

can withstand this high pressure such

as metal or concrete. Do not use on

wood. Do not use to clean vehicles.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Comments to this Manuals

No comments