LATHE DUPLICATOR ATTACHMENT(FOR USE WITH LATHE MODEL 90265)MODEL 90692ASSEMBLY AND OPERATING INSTRUCTIONS3491 Mission Oaks Blvd., Camarillo, CA 93011V
FIGURE GSAFETY SHIELD (8)HANDLE (51)SAFETY SHIELD PLATE (43)SUPPORT BAR (54)BOLTPAN HEAD SCREW (9)FLAT WASHER (21)HEX NUT (7)HEX HEAD BOLT (11)FLAT WA
3. The Cutting Tool (31) also can be adjusted vertically by loosening the SocketHead Bolt (25) which secures the Tool Holder (24) in place. Once adju
SKU 90692 PAGE 12occurs, have the problem corrected before further use.Do not use damaged equipment.2. For better and safer performance, always keep t
PARTS LISTSKU 90692 PAGE 13PLEASE READ THE FOLLOWING CAREFULLYTHE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LISTAND ASSEMBLY DIAGRAM IN T
NOTE: Some parts are listed and shown for illustration purposes only, and are notavailable individually as replacement parts.ASSEMBLY DIAGRAMSKU 9069
PRODUCT SPECIFICATIONSSAVE THIS MANUALYou will need this manual for the safety warnings and precautions, assembly,operating, inspection, maintenance a
SKU 90692 PAGE 33. Store idle equipment. When not in use, tools and equipment should be storedin a dry location to inhibit rust. Always lock up tool
SKU 90692 PAGE 4cannot cover all possible conditions and situations that may occur. The operatormust understand that common sense and caution are fac
SKU 90692 PAGE 5ASSEMBLY INSTRUCTIONSNOTE: For additional references to the parts listed in the following pages, refer to theAssembly Diagram on page
SKU 90692 PAGE 63. Install one Lower Vertical Support Bar (46) onto the Tool Rest Base of the lathe,and secure it by tightening the Support Bar Handle
SKU 90692 PAGE 7U-BRACKET (38)HANDLE (3)PATTERN SUPPORT BAR (41)PATTERN BOLT (42)LOWER VERTICALSUPPORT BAR(46)U-BRACKETASSEMBLYLOWER VERTICALSUPPORT B
SQUARE NUT (47)SQUARENUT(47)SUPPORT BAR (54)FLAT WASHER (40)LOCKWASHER (34)HANDLE (48)FLAT WASHER(40)LOCKWASHER(34)HANDLE(48)FIGURE DTo Assemble The T
To Attach The Tool Holder Assembly:1. Slide the Cutting Tool (31) of the Tool Holder (24) into the Slot located on theSide Plate (50). (See Figures E
Comments to this Manuals