Harbor Freight Tools 95004 User Manual

7-1/4” CIRCULAR SAWWITH LASER Model 95004ASSEMBLY AND OPERATING INSTRUCTIONS3491 Mission Oaks Blvd., Camarillo, CA 93011Visit our Web site at: htt

EXTENSION CORDS1.Grounded tools require a three wire extension cord. Double Insulated toolscan use either a two or three wire extension cord.2. As th

SYMBOLOGYSKU 95004 For technical questions, please call 1-800-444-3353 PAGE 11FIGURE DUNPACKINGWhen unpacking, check to make sure all t

SKU 95004 For technical questions, please call 1-800-444-3353 PAGE 123. Laser Switch (74): The Circular Saw is equipped with a Laser G

SKU 95004 For technical questions, please call 1-800-444-3353 PAGE 134. Depress the Spindle Lock (39) to hold the Spindle stationary. (

To Adjust The Angle Of Cut:1. The angle of cut may be adjusted from 90 degrees to 45 degrees.(See Figure H.)2. To adjust the angle of cut, loosen the

SKU 95004 For technical questions, please call 1-800-444-3353 PAGE 15BASIC OPERATING INSTRUCTIONS1. CAUTION! Always use safety equipme

INSPECTION, MAINTENANCE, AND CLEANING1. WARNING! Make sure the Power Switch (67) of the Circular Saw is in its“OFF” position and the tool is

charged “AAA” Batteries, making sure to match the poles (+ and --) as shown inthe Battery Compartment. Then, close the Laser Plate Cover (17).(See Fi

6. To clean the exterior parts of the Circular Saw, use only a clean cloth and milddetergent to clean the body of the Saw. Do not immerse any electri

ASSEMBLY DIAGRAMSKU 95004 For technical questions, please call 1-800-444-3353 PAGE 19NOTE:Some parts are listed and shown for illustrat

PRODUCT SPECIFICATIONSSAVE THIS MANUALYou will need this manual for the safety warnings and precautions, assembly,operating, inspection, maintenance a

Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purch

ELECTRICAL SAFETY4. Grounded tools must be plugged into an outlet properly installed andgrounded in accordance with all codes and ordinances. Never r

12. Avoid accidental starting. Be sure the Power Switch is off before pluggingin. Carrying power tools with your finger on the Power Switch, or plug

23. Use only accessories that are recommended by the manufacturer for yourmodel. Accessories that may be suitable for one tool may become hazardouswh

8. Before using the Circular Saw, check to make sure the Saw Blade is prop-erly mounted on the Spindle. Make sure the Saw Blade is sharp, and is notc

24. Causes and operator prevention of “kickback”: Kickback is a sudden reactionto a pinched, bound, or misaligned Saw Blade, causing an uncontrolled

SKU 95004 For technical questions, please call 1-800-444-3353 PAGE 826. WARNING! Some dust created by power sanding, sawing, gr

resistance path to carry electricity away from the user, reducing the risk of elec-tric shock. (See Figure A.)2. The grounding prong in the plug is c