Page 10 For technical questions, please call 1-800-444-3353. Item 60238 Workpiece and Work Area Set Up1. Designate a work area that is clean
Page 11For technical questions, please call 1-800-444-3353.Item 60238 General Operating Instructions1. Bring the drill bit down with the Feed
Page 12 For technical questions, please call 1-800-444-3353. Item 60238 Maintenance and Servicing Procedures not specifically explained in th
Page 13For technical questions, please call 1-800-444-3353.Item 60238 TroubleshootingProblem Possible Causes Likely SolutionsTool will not sta
Page 14 For technical questions, please call 1-800-444-3353. Item 60238 Record Product’s Serial Number Here: Note: If product has no serial nu
Page 15For technical questions, please call 1-800-444-3353.Item 60238 Assembly Diagram12348769101113141516123171821252427 26282923223031203519
Limited 90 Day WarrantyHarbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrant
Page 2 For technical questions, please call 1-800-444-3353. Item 60238 Table of ContentsSafety ...
Page 3For technical questions, please call 1-800-444-3353.Item 60238 Table A: RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS (120 VOLT)NA
Page 4 For technical questions, please call 1-800-444-3353. Item 60238 Grounding Instructions TO PREVENT ELECTRIC SHOCK AND DEATH FROM INCORRE
Page 5For technical questions, please call 1-800-444-3353.Item 60238 11. Industrial applications must follow OSHA guidelines.12. Maintain la
Page 6 For technical questions, please call 1-800-444-3353. Item 60238 SpecificationsElectrical Rating 120V~ / 60Hz / 2.4ASpindle Speeds760, 1
Page 7For technical questions, please call 1-800-444-3353.Item 60238 Table Support1. Loosen the Pivot Lever (51).2. Slide the Table Support
Page 8 For technical questions, please call 1-800-444-3353. Item 60238 Operating Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION se
Page 9For technical questions, please call 1-800-444-3353.Item 60238 Changing Drill SpeedBefore changing the speeds, make sure the machine is
Comments to this Manuals