Page 7For technical questions, please call 1-800-444-3353.SKU 68892
Maintenance And Servicing
Procedures not specically explained in this manual must
be performed only by a qualied technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected
before further use. Lock the lift with the Locking Bar (22) before servicing in the raised position.
1. Lower the lift completely. Remove the Access
Panel (36) and the Oil Plug (P23) underneath.
2. The oil level should be even with the bottom of the
3. If the oil level is low, add SAE Hydraulic Jack
Do not use any other uid or brake uid.
1. Before each use, inspect the general condition
of the Lift. Check for broken, cracked, or bent
parts, loose or missing parts, and any condition
that may affect the proper operation of the product.
If a problem occurs, have the problem corrected
before further use.
Do not use damaged equipment.
2. If the Lift appears not to be working
properly, follow Bleeding instructions.
3. The mechanical parts of the Lift, such as
the pedal lift and release shafts should be
occasionally lubricated with heavy oil or grease.
4. Protect the Lift Cylinder from dirt or grit when
in the raised position. If it becomes dirty, wipe
it off with a clean cloth before lowering.
5. Maintain and store the Lift in a reasonably
protected environment. Do not expose to rain
or excess moisture. Protect from salt water or
other corrosive materials. If it becomes dirty or
contaminated, clean it promptly with clean water or
a suitable detergent. If using a pressure washer,
be aware that you may remove some paint from
the outer surface. Never spray a pressure washer
at the seal areas near the pistons or valves.
Lubricate external moving parts after cleaning.
6. If the lift slowly lowers on its own, it may
First check the oil level. If the level is OK, take
replacement. Damaged seals may be caused by
overloading, or exposure to harmful conditions
or inappropriate use of a pressure washer.
NOTE: If the lift can be raised to its highest position,
it indicates that there is enough oil.
If the lift slowly lowers from this position, it indicates
that the problem is likely with the seals.
NOTE: Do not tamper with the check valves. Any
Checking and Filling Hydraulic Fluid
Note: If the Lift appears not to be working
properly, it may be necessary to bleed
trapped air from its hydraulic system.
1. Check oil level. Replace plug.
2. Depress Release Foot Pedal (10).
3. Pump the Foot Pedal (11) several times.
4. Let up on Release Foot Pedal (10).
5. Pump Lift Pedal (11). If the motorcycle lift does
not elevate smoothly or Pedal (11) feels “spongy”,
repeat steps 2 - 5.
Bleeding
(9 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals