Harbor Freight Tools OBD II & CAN Code Reader with Multilingual Menu Manual download pdf (Page 18)

z The control module number, sequence of the DTCs, total

number of codes detected and type of codes (Generic or

Manufacturer specific, Stored or Pending codes) will be

observed on the upper right hand corner of the display.

3) If more than one DTC is found, use SCROLL button, as

necessary, until all the codes have been shown up.

z If no codes are detected, a “No codes are stored in the

module!” message displays on the screen.

z If retrieved DTCs contain any manufacturer specific or

enhanced codes, the display indicates “Manufacturer

control”.

$09 4/6

P1324 Other

Manufacturer control

4) Press ENTER/EXIT button to return to previous menu.

4.2 Erasing Codes

CAUTION: Erasing the Diagnostic Trouble Codes may allow the

code reader to delete not only the codes from the vehicle’s on-board

computer, but also “Freeze Frame” data and manufacturer

enhanced data. Further, the I/M Readiness Monitor Status for all

vehicle monitors is reset to Not Ready or Not Complete status. Do not

erase the codes before the system has been checked completely by a

technician.

z This function is performed with key on engine off (KOEO). Do

not start the engine.

1) If you decide to erase the DTCs, use SCROLL button to select

Erase Codes from Diagnostics Menu and press ENTER/EXIT

button.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

No comments

Harbor Freight Tools OBD II & CAN Code Reader with Multilingual Menu Manual Page 18