Harbor Freight Tools Towable Ride_On Trencher Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
Page 19For technical questions, please call 1-888-866-5797.Item 62365
Fuel Filter Replacement (if equipped)
WARNING! TO PREVENT SERIOUS
INJURY FROM FIRE OR EXPLOSION:
Fill the fuel tank in a well-ventilated area
away from ignition sources. If the engine is
hot from use, shut the engine off and wait
for it to cool. Do not smoke.
1. Wear protective gear including, ANSI-
approved safety goggles, NIOSH-approved
dust mask/respirator, and nitrile gloves.
2. Clean the Fuel Cap and the area around it.
3. Remove Fuel Filter (6R). Reattach Fuel Cap to
prevent debris from entering into Gas Tank.
4. Remove Fuel Strainer. Wash with warm water
and light detergent. Flush and let dry.
5. Reinstall in the Gas Tank.
Engine Oil Change
CAUTION! Oil is very hot during operation and can
cause burns. Wait for engine to cool before changing oil.
1. Make sure the engine is stopped and is level.
2. Close the Fuel Valve.
3. Place a drain pan (not included) underneath
the Crankcase’s drain plug.
4. Remove the Drain Plug and, if possible,
tilt the Crankcase slightly to help drain
the oil out. Recycle used oil.
5. Replace the drain plug and tighten it.
6. Clean the top of the Dipstick and the area around it.
Remove the Dipstick by turning it counterclockwise,
and wipe it off with a clean, lint free rag.
7.
Full level
Full level
Add the appropriate type of oil until the oil level is at
the full level. SAE 10W-30 oil is recommended for
general use.
The SAE Viscosity Grade chart shows other
viscosities to use in different average temperatures.
10W-30
30
5W-30
-20 0 20 40 60 80 100°F
SAE Viscosity Grades
Average outdoor temperature
8. Thread the Dipstick back in clockwise.
NOTICE: Do not run the engine with too little oil.
The engine will be permanently damaged.
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Comments to this Manuals

No comments