Harbor Freight Tools 94187 User Manual download pdf (Page 14)

Page 14

SKU 94187 For technical questions, please call 1-800-444-3353

Replace Spark Plug by hand for the ﬁrst few turns, then tighten with the socket wrench

completely. Securely tighten. A Spark Plug with a new Gasket requires 1/2 more turns

to tighten than the used Gasket which requires 1/8 to 1/4 turns to tighten.

Changing Oil

Run the Engine for ﬁve minutes to warm up the oil, then shut off the Engine.

Place a drain pan under the Drain Plug.

Remove the Dip Stick and unscrew the Drain Plug.

Allow all the oil to drain out into the pan. Pour the used oil into a container with a lid.

Deliver used oil to a recycling center. Do not dump oil into the earth or storm drain.

Dispose of oil properly.

Replace Drain Plug and securely tighten.

Add 1/2 quart of 10W30 motor oil through a funnel (not included) into the Dip Stick ﬁll

hole. Fill until the oil reaches the Upper Level line of the ﬁll hole.

Replace the Dip Stick, being careful not to strip its plastic threads.

Cleaning the Deposit Cup

Push the Gas Valve to the closed (left) position.

Using a wrench (not supplied), loosen and remove the Bolt

under the Deposit Cup. Place a pan below the Deposit

Cup to catch any remaining gasoline.

Remove the Deposit Cup and O-ring, and wash them in

cleaning solvent.

Reinstall the Deposit Cup.

Push the Gas Valve to the open (right) position and check

for gas leaks from the Deposit Cup. If leaks are found, reinstall the Deposit Cup and

tighten hardware.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

No comments

Harbor Freight Tools 94187 User Manual Page 14