AIR FILTER SYSTEM - REMOTE CONTROLModel 46361OPERATING INFORMATION3491 Mission Oaks Blvd., Camarillo, CA 93011Visit our Web site at http://www.harborf
FILTER BAG (#2)FIGURE I5. If necessary, wipe the outside of the Air Filter System with a damp cloth. Youmay use a mild detergent.PLEASE READ THE FOLL
PARTS LISTNOTE: Some parts are listed and shown for illustration purposes only, and are notavailable individually as replacement parts.SKU 46361 PAGE
6. CHECK FOR DAMAGED PARTS. Before using this product, carefully check thatthe Air Filter System will operate properly and perform its intended funct
5. MAKE SURE THE POWER SWITCH (part #19) IS IN THE “OFF” POSITIONBEFORE PLUGGING IN THE POWER CORD.6. DO NOT ABUSE THE POWER CORD. Do not yank the Po
UNPACKINGWhen unpacking, check to make sure all parts shown on the Parts List (page 11) areincluded. If any parts are missing or broken, please call
5. Locate the desired ceiling location, and ceiling joists, upon which to attach the AirFilter System.6. With assistance and proper lifting equipment
2. When the manual Power Switch (part #19) is turned to its “NON-REMOTE CON-TROL” position, the Air Filter System will run continuously until the manu
SKU 46361 PAGE 8 REV 09/024. NOTE: The Remote Control requires a 9 Volt battery. To install a 9 Volt battery inthe Remote Control, remove the Batter
CLEANING AND MAINTENANCE1. Caution: Always disconnect the Air Filter System from its electrical supplysource before performing any cleaning, servicin
Comments to this Manuals